Clorhexidina y alcohol isopropílico (chlorhexidine and isopropyl alcohol)

Usos

patient preoperative skin preparation: for preparation of the skin prior to surgery helps reduce bacteria that potentially can cause skin infection Uses patient preoperative skin preparation: for preparation of the skin prior to surgery helps reduce bacteria that potentially can cause skin infection Uses patient preoperative skin preparation: for preparation of the skin prior to surgery helps reduce bacteria that potentially can cause skin infection

Advertencias

Instrucciones

(follow all directions for use) use with care in premature infants or infants under 2 months of age. These products may cause irritation or chemical burns. discard the applicator after a single use along with any portion of the solution not required to cover the prepped area. It is not necessary to use the entire amount available. Getting Patient Ready for Solution: use in well-ventilated area do not microwave or heat the solution applicator apply to clean, completely dry, residue-free, intact skin when hair removal is necessary, use a surgical clipper on the morning of the surgery. If a wet shave is used, thoroughly remove all soap residues. Activating the Applicator: remove applicator from package; do not touch sponge with sponge face parallel to the floor, press the cap end of the applicator. Solution will begin to flow into sponge. When Applying Solution: completely wet the treatment area with antiseptic dry surgical sites (e.g., abdomen or arm): use repeated back-and-forth strokes for 30 seconds moist surgical sites (e.g., inguinal fold): use repeated back-and-forth strokes for 2 minutes maximal treatment area for one applicator is approximately 13.2 in. x 21.6 in. (285.2 in 2 ). do not allow solution to pool ; tuck prep towels to absorb solution, and then remove clean umbilicus with enclosed swabs when applicable. (Moisten swabs by pressing against solution-soaked sponge applicator.) avoid getting solution into hairy areas. Wet hair is flammable . Hair may take up to 1 hour to dry. when prepping skin folds, toes, or fingers, use a sterile-gloved hand to hold skin apart until completely dry. After Applying Solution: to reduce the risk of fire, wait until solution is completely dry (minimum of 3 minutes on hairless skin; up to 1 hour in hair) While Waiting for Solution to Completely Dry: do not drape or use ignition source (e.g., cautery, laser) check for pooled solution. Use sterile gauze to soak up pooled solution. Do not blot because it may remove solution from skin. remove wet materials from prep area. Replace if necessary. After Solution is Completely Dry: to reduce the risk of fire, begin draping and/or using cautery only after solution is completely dry and all wet materials are removed if incise drapes are used, apply directly to dry prep apply dressing following standard practices Directions (follow all directions for use) use with care in premature infants or infants under 2 months of age. These products may cause irritation or chemical burns. discard the applicator after a single use along with any portion of the solution not required to cover the prepped area. It is not necessary to use the entire amount available. Getting Patient Ready for Solution: use in well-ventilated area do not microwave or heat the solution applicator apply to clean, completely dry, residue-free, intact skin when hair removal is necessary, use a surgical clipper on the morning of the surgery. If a wet shave is used, thoroughly remove all soap residues. Activating the Applicator: remove applicator from package; do not touch sponge grasp products by wrapping hand and fingers around the labeled portion of the applicator. Place thumb on the lever with sponge face parallel to the floor, snap lever to allow fluid to flow into sponge. When Applying Solution: completely wet the treatment area with antiseptic dry surgical sites (e.g., abdomen or arm): use repeated back-and-forth strokes for 30 seconds moist surgical sites (e.g., inguinal fold): use repeated back-and-forth strokes for 2 minutes maximal treatment area for one applicator is approximately 8.4 in. x 15.6 in. (131.4 in 2 ). do not allow solution to pool ; tuck prep towels to absorb solution, and then remove avoid getting solution into hairy areas. Wet hair is flammable . Hair may take up to 1 hour to dry. when prepping skin folds, toes, or fingers, use a sterile-gloved hand to hold skin apart until completely dry. After Applying Solution: to reduce the risk of fire, wait until solution is completely dry (minimum of 3 minutes on hairless skin; up to 1 hour in hair) While Waiting for Solution to Completely Dry: do not drape or use ignition source (e.g., cautery, laser) check for pooled solution. Use sterile gauze to soak up pooled solution. Do not blot because it may remove solution from skin. remove wet materials from prep area. Replace if necessary. After Solution is Completely Dry: to reduce the risk of fire, begin draping and/or using cautery only after solution is completely dry and all wet materials are removed if incise drapes are used, apply directly to dry prep apply dressing following standard practices Directions (follow all directions for use) use with care in premature infants or infants under 2 months of age. These products may cause irritation or chemical burns. discard the applicator after a single use along with any portion of the solution not required to cover the prepped area. It is not necessary to use the entire amount available. Getting Patient Ready for Solution: use in well-ventilated area do not microwave or heat the solution applicator apply to clean, completely dry, residue-free, intact skin when hair removal is necessary, use a surgical clipper on the morning of the surgery. If a wet shave is used, thoroughly remove all soap residues. Activating the Applicator: remove applicator from package; do not touch sponge grasp product by wrapping hand and fingers around the labeled portion of the applicator. Place thumb on the lever with sponge face parallel to the floor, snap lever to allow fluid to flow into sponge. When Applying Solution: completely wet the treatment area with antiseptic dry surgical sites (e.g., abdomen or arm): use repeated back-and-forth strokes for 30 seconds moist surgical sites (e.g., inguinal fold): use repeated back-and-forth strokes for 2 minutes maximal treatment area for one applicator is approximately 8.4 in. x 15.6 in. (131.4 in 2 ) do not allow solution to pool ; tuck prep towels to absorb solution, and then remove avoid getting solution into hairy areas. Wet hair is flammable . Hair may take up to 1 hour to dry. when prepping skin folds, toes, or fingers, use a sterile-gloved hand to hold skin apart until completely dry. After Applying Solution: to reduce the risk of fire, wait until solution is completely dry (minimum of 3 minutes on hairless skin; up to 1 hour in hair) While Waiting for Solution to Completely Dry: do not drape or use ignition source (e.g., cautery, laser) check for pooled solution. Use sterile gauze to soak up pooled solution. Do not blot because it may remove solution from skin. remove wet materials from prep area. Replace if necessary. After Solution is Completely Dry: to reduce the risk of fire, begin draping and/or using cautery only after solution is completely dry and all wet materials are removed if incise drapes are used, apply directly to dry prep apply dressing following standard practices

Otra información

store between 15-30 °C (59-86 °F) avoid freezing and excessive heat above 40 °C (104 °F) The tint will slowly fade from the skin. For early removal of surgical prep use soap and water or 70% Isopropyl Alcohol. Other information store between 15-30 °C (59-86 °F) avoid freezing and excessive heat above 40 °C (104 °F) The tint will slowly fade from the skin. For early removal of surgical prep use soap and water or 70% Isopropyl Alcohol. Other information store between 15-30 °C (59-86 °F) avoid freezing and excessive heat above 40 °C (104 °F)

Ingredientes inactivos

acetyltri-n-butyl citrate, FD&C blue #1, FD&C yellow #5, purified water USP, Trisodium HEDTA Inactive ingredients acetyltri-n-butyl citrate, FD&C blue #1, FD&C yellow #5, purified water USP, Trisodium HEDTA Inactive ingredients acetyltri-n-butyl citrate, purified water USP, Trisodium HEDTA

¿Preguntas?

call 1-800-228-3957 (Monday-Friday 7AM-6PM CST). www.3M.com/Medical 34-8727-1905-8 Questions? call 1-800-228-3957 (Monday-Friday 7AM-6PM CST). www.3M.com/Medical 34-8727-1906-6 Questions? call 1-800-228-3957 (Monday-Friday 7AM-6PM CST). www.3M.com/Medical 34-8727-1907-4

Usos

for the preparation of the patient's skin prior to surgery or injection

Advertencias

Instrucciones

use with care in premature infants or infants under 2 months of age. These products may cause irritation or chemical burns. maximum treatment area for one maxi swabstick is approximately: dry site: 4 by 4 inches (10 by 10 cm) or moist site: 3 by 5 inches (7.5 by 12.5 cm) tear open the pouch to expose the swabstick remove the swabstick from package. Do not touch the foam tip. prior to surgery or injection, apply one flat side of foam tip to the proposed skin site and prep the skin in vigorous back-and-forth repeated strokes, turning the swabstick over (unused side of the foam tip) half way in the procedure dry site: scrub repeatedly back and forth for 15 seconds with each side of the applicator for a total of 30 seconds. Allow to air dry for approximately 30 seconds. moist site: scrub repeatedly back and forth for 1 minute with each side of the applicator for a total of 2 minutes. Allow to air dry for approximately 1.5 minutes. do not blot or wipe dry discard after a single use

Ingredientes inactivos

USP purified water

Usos

Usage For skin antisepsis prior to an invasive procedure. Helps reduce bacteria content that could cause skin infections.

Advertencias

Instrucciones

Dosage Apply to areas that need to be disinfected

Ingredientes inactivos

Water